Water Inlet Hoses - Whirlpool HE2t - 3.7 cu. Ft. Front Load Washer User Manual

User guide
Table of Contents

Advertisement

8.
Once the cycle has begun, allow the cycle
to complete.
9.
After the cycle is complete, leave the door
open, slightly, to allow for better ventilation
and drying of washer interior.
Always do the following to maintain washer
freshness
Use only HE High Efficiency detergent.
Leave the door slightly open after each cycle
to allow for better ventilation and drying of
washer interior.
Repeat the cleaning procedure monthly,
using 2/3 cup (160 mL) of liquid chlorine
bleach.
If the procedure does not sufficiently improve
the machine freshness, please evaluate your
installation and usage conditions for other
causes.
Cleaning the exterior
Use a soft damp cloth or sponge to wipe up
any spills. Occasionally wipe the outside of your
washer to keep it looking new. Use mild soap
and water. Do not use abrasive products.
Cleaning the dispenser drawer
The dispenser drawer is removable for easy
cleaning.
1.
Unlock the dispenser drawer by pressing
the Release Lever. See "Using the Dis-
penser." Remove the drawer.
2.
Remove the inserts (the siphon from the
softener and bleach compartments).
3.
Wash the parts under running water.
NOTE: Do not wash components in the
dishwasher.
4.
Replace the inserts and return the dis-
penser to the drawer.

WATER INLET HOSES

Replace inlet hoses after five years of use to
reduce the risk of hose failure. Periodically in-
spect and replace inlet hoses if bulges, kinks,
cuts, wear or leaks are found.
When replacing your inlet hoses, record the
date of replacement.
VACATION, STORAGE, &
MOVING CARE
Install and store your washer where it will not
freeze. Because some water may stay in the
hoses, freezing can damage your washer. If
storing or moving your washer during freezing
weather, winterize it.
Non-use or vacation care:
Operate your washer only when you are at
home. If you will be on vacation or not using
your washer for an extended period of time,
you should:
Unplug washer or disconnect power.
Turn off the water supply to the washer. This
helps avoid accidental flooding (due to a water
pressure surge) while you are away.
Slightly open door to provide ventilation.
To winterize washer:
1.
Put 1 qt (1 L) of R.V.-type antifreeze in the
drum.
2.
Run washer on a Drain/Spin cycle.
3.
Unplug washer or disconnect power.
4.
Shut off both water faucets.
5.
Disconnect water inlet hoses from faucets
and drain.
To use washer again:
1.
Flush water pipes.
2.
Reconnect water inlet hoses to faucets.
3.
Turn on both water faucets.
3-13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents