Removing An Interlock Switch - Whirlpool HE2t - 3.7 cu. Ft. Front Load Washer User Manual

REMOVING AN INTERLOCK SWITCH

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. If you are servicing the rear interlock
switch, pull the washer away from the
wall, and remove the rear panel from the
washer (see page 4-20 for the proce-
dure).
If you are servicing the front interlock
switch, remove the lower front access
panel (see step 10 on page 4-11 for the
procedure).
Front Interlock Switch
Rear Interlock Switch
4-25
4. Press the two locking tabs in to release
them, and slide the switch holder up and
out of the chassis cutout.
Locking Tabs Release
5. Disconnect the two wires from the switch
terminals and unhook the wires from the
clips.
Wire Clips
Continued on the next page.
Interlock Switch
Wire Connectors