Whirlpool HE2t - 3.7 cu. Ft. Front Load Washer User Manual page 70

24. To replace the tub gasket, pry the gas-
ket out of the slot, and remove it. NOTE:
The tub gasket hub is molded into the
rear half of the tub. If it is worn and needs
to be replaced, replace the rear half of
the tub.
Rear Of Tub
Basket Hub
Tub Gasket
25. To replace a basket baffle (see the
right column photos):
a) Position the basket with the baffle to
be removed on top.
b) Using a flat-blade screwdriver, pry up
on the two basket locking tabs so they
are above the baffle stops.
c) Reach inside the basket, and slide the
baffle toward the opening until the tabs
are aligned with the large basket slots,
then lower the baffle, and remove it
from the basket.
NOTE: When you reinstall the baffle,
make sure that you press the two bas-
ket locking tabs down below the baffle
stops.
Baffle Mounting Tabs
Baffle Stops
4-32
Basket Tabs
Pry Up Basket Tabs