Default Users And Passwords; Changing Default Passwords; Upgrading Software Using The Cli - 3Com 3CRDSF9PWR-US - OfficeConnect Managed Fast Ethernet PoE Switch User Manual

Default Users and
Passwords
Changing Default
Passwords
Upgrading
Software using the
CLI
To display and configure SNMP management parameters, refer to
"Configuring SNMP" on page 163.
If you intend to manage the switch or to change the default passwords,
you must log in with a valid user name and password. The switch has two
default user names. The default users are listed in Table 5.
Table 5 Default Users
Default
User Name Password
admin (no password)
monitor monitor
Use the admin default user name (no password) to log in and carry out
initial switch setup.
You can change the default passwords using either:
The username command on the CLI, or
■
The Administration > System Access > Modify operation on the web
■
interface.
This section describes how to upgrade software to your switch from the
Command Line Interface (CLI).
Note: You can also upgrade the software using the switch Web user
interface. See "Restoring the Software Image" page 197. Bootcode can
only be upgraded using the CLI, for which instructions are supplied in the
release notes.
1 To download the runtime application file, enter the following commands:
copy tftp file
Console#
TFTP server IP address:
Choose file type:
1. config: 2. opcode: <1-2>:
Source file name:
Destination file name:

Default Users and Passwords

Access Level
Management — The user can access and change
all manageable parameters
Monitor — the user can view all manageable
parameters, but cannot change any manageable
parameters
aaa.aaa.aaa.aaa
2
rrr
rrr
33