Electrical; Switch Features - 3Com 3CRDSF9PWR-US - OfficeConnect Managed Fast Ethernet PoE Switch User Manual

230 A B: D
PPENDIX EVICE

Electrical

Switch Features

Table 13 Features of the OfficeConnect Managed Fast Ethernet PoE Switch
Feature
Auto Negotiation
Automatic MAC Addresses Aging
Back Pressure
Address Resolution Protocol (ARP)
Class Of Service (CoS)
Command Line Interface
S F
PECIFICATIONS AND EATURES
Line Frequency
Input Voltage
Current Rating
Maximum Power
Consumption
Max Heat Dissipation
This section describes the device features. The system supports the
following features:
Description
The purpose of auto negotiation is to allow a device to advertise modes of
operation. The auto negotiation function provides the means to exchange
information between two devices that share a point-to-point link
segment, and to automatically configure both devices to take maximum
advantage of their abilities.
Auto negotiation is performed totally within the physical layers during link
initiation, without any additional overhead to either the MAC or higher
protocol layers. Auto negotiation allows the ports to do the following:
Advertise their abilities
■
Acknowledge receipt and understanding of the common modes of
■
operation that both devices share
Reject the use of operational modes that are not shared by both
■
devices
Configure each port for the highest-level operational mode that both
■
ports can support
MAC addresses from which no traffic is received for a given period are
aged out. This prevents the Bridging Table from overflowing.
On half duplex links, the receiver may employ back pressure (i.e. occupy
the link so it is unavailable for additional traffic), to temporarily prevent
the sender from transmitting additional traffic. This is used to prevent
buffer overflows.
ARP converts between IP addresses and MAC (i.e., hardware) addresses.
ARP is used to locate the MAC address corresponding to a given IP
address.
Provide traffic belonging to a group preferential service (in terms of
allocation of system resources), possibly at the expense of other traffic.
The Command Line Interface (CLI) is an interface using a serial connection
that allows the switch to be configured.
50/60 Hz
100–240 Vac (auto range)
2.0 Amp (Max)
200.3 BTU/hr (88 Watts)
200.3 BTU/hr