Defining ARP Settings
The ARP Settings Setup Page allows network managers to define ARP
parameters for specific interfaces.
Monitor users have no access to this page.
To configure ARP entries:
1 Click Administration > ARP Settings > Setup. The ARP Settings Setup
Page opens:
Figure 76 ARP Settings Setup Page
The ARP Settings Setup Page contains the following fields:
IP Address— Defines the station IP address, which is associated with
■
the MAC address. Note that this address must be within the same IP
subnet as that assigned to the switch (see Defining IP Addressing on
page 142).
MAC Address — Defines the station MAC address, which is
■
associated in the ARP table with the IP address.
ARP Entry Age Out — Specifies the amount of time (in seconds) that
■
passes between ARP Table entry requests. Following the ARP Entry
Age period, the entry is deleted from the table. The range is 1-86400
seconds. The default value is 1200 seconds.
2 Define the fields.
3 Click
. The ARP parameters are defined, and the device is
updated.
Configuring ARP Settings
145