Table of Contents
Advertisement
D-Link DES-3010FA/GA CLI Reference Guide
dot1x timeout quiet-period
The dot1x timeout quiet-period Interface Configuration mode command sets the number of seconds that the
device remains in the quiet state following a failed authentication exchange (for example, the client provided an
invalid password). To return to the default configuration, use the no form of this command.
Syntax
dot1x timeout quiet-period seconds
no dot1x timeout quiet-period
Parameters
•
seconds — Specifies the time in seconds that the device remains in the quiet state following a failed authenti-
cation exchange with the client. (Range: 0 - 65535 seconds)
Default Configuration
Quiet period is 60 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
During the quiet period, the device does not accept or initiate authentication requests.
The default value of this command should only be changed to adjust for unusual circumstances, such as unreli-
able links or specific behavioral problems with certain clients and authentication servers.
To provide a faster response time to the user, a smaller number than the default value should be entered.
Examples
The following example sets the number of seconds that the device remains in the quiet state following a failed
authentication exchange to 3600.
Console(config)# interface ethernet 6
Console(config-if)# dot1x timeout quiet-period 3600
Page 323
Advertisement
Table of Contents
