Table of Contents
Advertisement
D-Link DES-3010FA/GA CLI Reference Guide
snmp-server host
The snmp-server host Global Configuration mode command specifies the recipient of Simple Network Manage-
ment Protocol Version 1 or Version 2 notifications. To remove the specified host, use the no form of this command.
Syntax
snmp-server host {ip-address | hostname} community-string [traps | informs] [1 | 2] [udp-port port] [filter filter-
name] [timeout seconds] [retries retries]
no snmp-server host {ip-address | hostname} [traps | informs]
Parameters
•
ip-address — Specifies the IP address of the host (targeted recipient).
•
hostname — Specifies the name of the host. (Range:1-158 characters)
•
community-string — Specifies a password-like community string sent with the notification operation.
(Range: 1-20)
•
traps — Indicates that SNMP traps are sent to this host. If unspecified, SNMPv2c traps are sent to the host.
•
informs — Indicates that SNMP informs are sent to this host. Not applicable to SNMPv1.
•
1 — Indicates that SNMPv1 traps will be used.
•
2 — Indicates that SNMPv2c traps will be used.
•
port — Specifies the UDP port of the host to use. If unspecified, the default UDP port number is 162.
(Range:1-65535)
•
filtername — Specifies a string that defines the filter for this host. If unspecified, nothing is filtered.
(Range: 1-30 characters)
•
seconds — Specifies the number of seconds to wait for an acknowledgment before resending informs. If
unspecified, the default timeout period is 15 seconds. (Range: 1-300)
•
retries — Specifies the maximum number of times to resend an inform request. If unspecified, the default
maximum number of retries is 3. (Range: 1-255)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
When configuring an SNMPv1 or SNMPv2c notification recipient, a notification view for that recipient is automati-
cally generated for all the MIB.
When configuring an SNMPv1 notification recipient, the Inform option cannot be selected.
If a trap and inform are defined on the same target, and an inform was sent, the trap is not sent.
Example
The following example enables SNMP traps for host 10.1.1.1 with community string "management" using
SNMPv2c.
Console(config)# snmp-server host 10.1.1.1 management 2
Page 207
Advertisement
Table of Contents
