Snmp-Server Filter - D-Link DES-3010FA-TAA - Switch 10/100MBPS Mgmt Manual

snmp-server filter

The snmp-server filter Global Configuration mode command creates or updates a Simple Network Management
Protocol (SNMP) server filter entry. To remove the specified SNMP server filter entry, use the no form of this com-
mand.
Syntax
snmp-server filter filter-name oid-tree {included | excluded}
no snmp-server filter filter-name [oid-tree]
Parameters
•
filter-name—Specifies the label for the filter record that is being updated or created. The name is used to ref-
erence the record. (Range: 1-30 characters)
•
oid-tree—Specifies the object identifier of the ASN.1 subtree to be included or excluded from the view. To
identify the subtree, specify a text string consisting of numbers, such as 1.3.6.2.4, or a word, such as system.
Replace a single subidentifier with the asterisk (*) wildcard to specify a subtree family; for example, 1.3.*.4.
•
included—Indicates that the filter type is included.
•
excluded—Indicates that the filter type is excluded.
Default Configuration
No filter entry exists.
Command Mode
Global Configuration mode
User Guidelines
This command can be entered multiple times for the same filter record. Later lines take precedence when an
object identifier is included in two or more lines.
Examples
The following example creates a filter that includes all objects in the MIB-II system group except for sysServices
(System 7) and all objects for interface 1 in the MIB-II interfaces group.
Console(config)# snmp-server filter filter-name system included
Console(config)# snmp-server filter filter-name system.7 excluded
Console(config)# snmp-server filter filter-name ifEntry.*.1 included
Page 206
SNMP Commands