Install The Front Bezel - HP L1000 - 9000 - 0 MB RAM Manual

Installation
Connecting the Server to DC Power Source

Install the front Bezel.

The following procedure is for the installation of the two piece bezel. For information on
NOTE
installing the one piece bezel, refer to the rp5400 Series of Servers One Piece Bezel
Installation Instructions located at http://docs.hp.com.
1. Swing the Disk Media access door open so that the plastic pins that go into the metal clips on the Disk
Media bay are exposed.
The plastic pins holding the bezel on the right side are inserted into metal clips on the Disk
CAUTION
Media bay. DO NOT bend the plastic pins or they will break off.
2. Holding the bezel with both hands, align the bezel pins with the metal clips on the Disk Media bay and
carefully slide the bezel pins into the clips.
3. Attach the left side of the bezel to the server chassis by aligning the bezel pins (item 1) with the chassis
clips (item 2) and press the bezel into the chassis until the pins snap into the clips.
The illustration below shows the front bezel with locations of bezel pins and chassis clips.
4. Swing the Disk Media access door closed and attach to the right side of the server chassis.
5. Secure the bezel by wrapping the bezel strap around the bezel to prevent the bezel doors from opening.
Make sure the bezel strap pull tab is visible.
Figure 1-12
26
Installing the Front Bezel
Chapter 1