Table of Contents
Advertisement
Back to Contents Page
Replacing a PCI Express Card
Dell Studio XPS™ 435MT Service Manual
Removing a PCI Express Card
Installing a PCI Express Card
Replacing the Card Retention Bracket
Configuring Your Computer After Removing or Installing a PCI Express Card
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Removing a PCI Express Card
1. Uninstall the PCI Express card's driver and software from the operating system. For more information, see the Setup Guide.
2. Follow the procedures in
Before You
3. Remove the computer cover (see
4. Remove the screw that secures the card retention bracket.
5. Lift the card retention bracket and set it aside in a secure place.
1 card retention bracket 2 filler bracket
6. If applicable, disconnect any cables connected to the card.
7. Press the securing tab, grasp the card by its top corners, and then ease it out of its connector.
1
PCI Express x16 card
3
PCI Express x1 card
5
PCI Express x16 card slot
8. If you are replacing an existing card, go to
CAUTION:
Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the computer. The brackets also
keep dust and dirt out of your computer.
Begin.
Replacing the Computer
Cover).
2
securing tab
4
PCI Express x1 card slot
step 6
of
Installing a PCI Express
Card.
Hide quick links:
Advertisement
Table of Contents
