Logging Out Of The Fwsm - Cisco 7604 Configuration Manual

Connecting to the Firewall Services Module
To session in to the FWSM from the switch, log in, access privileged mode, and then configuration mode,
perform the following steps:
Session in to the FWSM from the switch using the command appropriate for your switch operating
Step 1
system:
•
•
For multiple context mode, when you session in to the FWSM, you access the system configuration. See
Chapter 4, "Configuring Security Contexts,"
Log in to the FWSM by entering the login password at the following prompt:
Step 2
hostname passwd:
By default, the password is cisco.
To change the password, see the
To access privileged EXEC mode, enter the following command:
Step 3
hostname> enable
This command accesses the highest privilege level.
The following prompt appears:
Password:
Step 4 Enter the enable password at the prompt.
By default, the password is blank, and you can press the Enter key to continue. See the
Passwords" section on page 7-1
The prompt changes to:
hostname#
To exit privileged mode, enter disable. You can also enter exit or quit to exit the current access mode
(privileged EXEC mode, global configuration mode, and so on).
Step 5 To access configuration mode, enter the following command:
hostname# configure terminal
The prompt changes to the following:
hostname(config)#

Logging out of the FWSM

To end the FWSM session and access the switch CLI, enter the following command:
hostname# exit
Logoff
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
3-2
Cisco IOS software
Router# session slot number processor 1
Catalyst operating system software
Console> (enable) session module_number
Chapter 3 Connecting to the Firewall Services Module and Managing the Configuration
for more information.
"Changing the Passwords" section on page
to change the enable password.
7-1.
"Changing the
OL-20748-01