Cisco 7604 Configuration Manual page 289

Chapter 14 Configuring Failover
Table 14-4
Field
Viewing Failover Status for Active/Active
The following is sample output from the show failover command for Active/Active failover.
provides descriptions for the information shown.
hostname# show failover
Failover On
Failover unit Primary
Failover LAN Interface: fover Vlan 100 (up)
Unit Poll frequency 1 seconds, holdtime 15 seconds
Interface Poll frequency 4 seconds
Interface Policy 1
Monitored Interfaces 8 of 250 maximum
failover replication http
Group 1 last failover at: 13:40:18 UTC Dec 9 2004
Group 2 last failover at: 13:40:06 UTC Dec 9 2004
This host:
Group 1
Group 2
Other host:
Group 1
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Show Failover Display Description (continued)
VPN IPSEC upd
VPN CTCP upd
VPN SDI upd
VPN DHCP upd
GTP PDP
GTP PDPMCB
Logical Update Queue
Information
Recv Q
Xmit Q
Primary
State:
Active time:
State:
Active time:
admin Interface outside (10.132.8.5): Normal
admin Interface third (10.132.9.5): Normal
admin Interface inside (10.130.8.5): Normal
admin Interface fourth (10.130.9.5): Normal
ctx1 Interface outside (10.1.1.1): Normal
ctx1 Interface inside (10.2.2.1): Normal
ctx2 Interface outside (10.3.3.2): Normal
ctx2 Interface inside (10.4.4.2): Normal
Secondary
State:
Active time:
Options
IPSec connection information.
cTCP tunnel connection information.
SDI AAA connection information.
Tunneled DHCP connection information.
GTP PDP update information. This information appears only if inspect
GTP is enabled.
GTP PDPMCB update information. This information appears only if
inspect GTP is enabled.
For each field type, the following statistics are used:
Cur—Current number of packets
•
Max—Maximum number of packets
•
Total—Total number of packets
•
The status of the receive queue.
The status of the transmit queue.
Active
2896 (sec)
Standby Ready
0 (sec)
Standby Ready
190 (sec)
Configuring Failover
Table 14-5
14-35