Common Problems - Cisco 7604 Configuration Manual

Catalyst 6500 series switch and cisco 7600 series router firewall services module configuration guide using the cli
Hide thumbs Also See for 7604:
Table of Contents

Advertisement

Common Problems

Common Problems
This section describes common problems with the FWSM, and how you might resolve them.
Symptom
partition.
Symptom
partition.
Symptom
Symptom
Symptom
Symptom
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
26-10
When you reset the FWSM from the switch CLI, the system always boots in to the maintenance
The default boot partition is set to cf:1.
Possible Cause
Recommended Action
Change the default boot partition according to the
Partition" section on page
You are unable to log in to the maintenance partition with the same password as the application
Possible Cause
The application partition and the maintenance partition have different password
databases.
Use the password appropriate for your partition. See the
Recommended Action
Passwords" section on page 7-1
Traffic does not pass through the FWSM.
The VLANs are not configured on the switch or are not assigned to the FWSM.
Possible Cause
Configure the VLANs and assign them to the FWSM according to the
Recommended Action
"Assigning VLANs to the Firewall Services Module" section on page
You cannot configure a VLAN interface within a context.
Possible Cause
You did not assign that VLAN to the context.
Assign VLANs to contexts according to the
Recommended Action
section on page
4-27.
You cannot add more than one switched virtual interface (SVI) to the MSFC.
You did not enable multiple SVIs.
Possible Cause
Recommended Action
Enable multiple SVIs according to the
the MSFC" section on page
You cannot make a Telnet connection or SSH to the FWSM interface.
Possible Cause
You did not enable Telnet or SSH to the FWSM.
Enable Telnet or SSH to the FWSM according to the
Recommended Action
section on page 23-1
or the
Chapter 26
2-10.
for more information.
2-4.
"Allowing SSH Access" section on page
Troubleshooting the Firewall Services Module
"Setting the Default Boot
"Changing the
2-2.
"Configuring a Security Context"
"Adding Switched Virtual Interfaces to
"Allowing Telnet Access"
23-2.
OL-20748-01

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7609-s76137606-sCatalyst 6500 series7600 series

Table of Contents