Setting The Hostname - Cisco 7604 Configuration Manual

Chapter 7 Configuring Basic Settings
Enter the new password again:
Step 7
Retype new password:
passwd: all authentication tokens updated successfully
Change the guest password by entering the following command:
Step 8
root@localhost# passwd-guest
Enter the new password at the prompt:
Step 9
Changing password for user guest
New password:
Enter the new password again:
Step 10
Retype new password:
passwd: all authentication tokens updated successfully
The following example shows how to set the password for the root account:
root@localhost# passwd
Changing password for user root
New password: *sh1p
Retype new password: *sh1p
passwd: all authentication tokens updated successfully
The following example shows how to set the password for the guest account:
root@localhost# passwd-guest
Changing password for user guest
New password: f1rc8t
Retype new password: f1rc8t
passwd: all authentication tokens updated successfully

Setting the Hostname

When you set a hostname for the FWSM, that name appears in the command-line prompt. If you
establish sessions to multiple devices, the hostname helps you keep track of where you enter commands.
When using failover, you can specify both a primary and secondary hostname.
Using both primary and secondary hostnames lets you use "tagged" logging. After enabling the logging
device-hostname command, all syslog messages will be tagged with either the primary or the secondary
hostname.
For example, within a context, you configure the primary hostname to be context-CTX1-primary and the
secondary hostname to be context-CTX1-secondary.
Primary-FWSM/4/act/CTX1(config)# logging console debug
context-CTX1-primary %FWSM-5-111008: User 'enable_15' executed the 'logging cons debug'
command.
For secondary/CTX1 which is in standby state below output will be seen.
Secondary-FWSM/4/act/CTX1(config)# logging console debug
**** WARNING ****
Configuration Replication is NOT performed from Standby unit to Active unit.
Configurations are no longer synchronized.
context-CTX1-secondary %FWSM-5-111008: User 'enable_15' executed the 'logging console
debug' command.
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Setting the Hostname
7-3