Enabling Snmp - Cisco 7604 Configuration Manual

Configuring SNMP
Table 25-3 SNMP MIB and Trap Support (continued)
MIB and Trap
NAT-MIB
RFC1213-MIB
SNMP core traps
SNMPv2-MIB
TCP-MIB
UDP-MIB

Enabling SNMP

This section describes how to enable SNMP on the FWSM. The SNMP agent that runs on the FWSM
performs two functions:
•
•
To enable the SNMP agent and identify an NMS that can connect to the FWSM, perform the following
steps:
To ensure that the SNMP server on the FWSM is enabled, enter the following command:
Step 1
hostname(config)# snmp-server enable
The SNMP server is enabled by default.
To identify the IP address of the NMS that can connect to the FWSM, enter the following command:
Step 2
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
25-32
Description
The FWSM supports browsing of the MIB.
The FWSM sends the following trap:
•
The FWSM supports browsing of the following tables:
•
•
The FWSM supports browsing of the following table:
•
The FWSM sends the following SNMP core traps:
•
•
•
•
The FWSM supports browsing of the following:
•
The FWSM supports browsing of the following table:
•
The FWSM supports browsing of the following table:
•
Replies to SNMP requests from NMSs.
Sends traps (event notifications) to NMSs.
packet-discard
natAddrBindTable
natAddrPortBindTable
ip.ipAddrTable
authentication—An SNMP request fails because the NMS did not
authenticate with the correct community string.
linkup—An interface has transitioned to the "up" state.
linkdown—An interface is down, for example, if you removed the
nameif command.
coldstart—The FWSM is running after a reload.
snmp
tcpConnectionTable
udpEndpointTable
Chapter 25 Monitoring the Firewall Services Module
OL-20748-01