Configuring Ipv6 On An Interface - Cisco 7604 Configuration Manual

Configuring IPv6 on an Interface

•
•
•
•
•
Failover does not support IPv6. The ipv6 address command does not support setting standby addresses
Note
for failover configurations. The failover interface ip command does not support using IPv6 addresses
on the failover and Stateful Failover interfaces.
When entering IPv6 addresses in commands that support them, simply enter the IPv6 address using
standard IPv6 notation, for example
and processes the IPv6 address. However, you must enclose the IPv6 address in square brackets ([ ]) in
the following situations:
•
•
The following commands were modified to work for IPv6:
•
•
•
•
•
The following inspection engines support IPv6:
•
•
•
Configuring IPv6 on an Interface
At a minimum, each interface needs to be configured with an IPv6 link-local address. Additionally, you
can add a site-local and global addresses to an interface.
FWSM does not support IPv6 anycast addresses.
Note
You can configure both IPv6 and IPv4 addresses on an interface.
You cannot configure IPv6 on an interface that is used by more than one context (a shared VLAN).
Note
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
10-2
ssh
telnet
tftp-server
who
write
You need to specify a port number with the address, for example:
[fe80::2e0:b6ff:fe01:3b7a]:8080
The command uses a colon as a separator, such as the write net and config net commands. For
example:
configure net [fe80::2e0:b6ff:fe01:3b7a]:/tftp/config/pixconfig
debug
fragment
ip verify
mtu
icmp (entered as ipv6 icmp)
ICMP
TCP
UDP
ping fe80::2e0:b6ff:fe01:3b7a
Chapter 10 Configuring IPv6
. The FWSM correctly recognizes
OL-20748-01