Reloading A Security Context; Reloading By Clearing The Configuration; Reloading By Removing And Readding The Context - Cisco 7604 Configuration Manual

Managing Security Contexts
To enter the new URL, enter the following command:
Step 4
hostname(config)# config-url new_url
The system immediately loads the context so that it is running.

Reloading a Security Context

You can reload the context in two ways:
•
•
This section includes the following topics:
•
•

Reloading by Clearing the Configuration

To reload the context by clearing the context configuration, and reloading the configuration from the
URL, perform the following steps:
To change to the context that you want to reload, enter the following command:
Step 1
hostname# changeto context name
To access configuration mode, enter the following command:
Step 2
hostname/name# configure terminal
Step 3 To clear the running configuration, enter the following command:
hostname/name(config)# clear configure all
This command clears all connections.
To reload the configuration, enter the following command:
Step 4
hostname/name(config)# copy startup-config running-config
The FWSM copies the configuration from the URL specified in the system configuration. You cannot
change the URL from within a context.
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
4-34
Clear the running configuration and then import the startup configuration.
This action clears most attributes associated with the context, such as connections and NAT tables.
Remove the context from the system configuration.
This action clears additional attributes, such as memory allocation, which might be useful for
troubleshooting. However, to add the context back to the system requires you to respecify the URL
and interfaces.
Reloading by Clearing the Configuration, page 4-34
Reloading by Removing and Readding the Context, page 4-35
Chapter 4 Configuring Security Contexts
OL-20748-01