Cisco 7604 Configuration Manual page 552

Installing Application or ASDM Software
For example:
Router# show boot device
[mod:1 ]:
[mod:2 ]:
[mod:3 ]:
[mod:4 ]: cf:4
[mod:5 ]: cf:4
[mod:6 ]:
[mod:7 ]: cf:4
[mod:8 ]:
[mod:9 ]:
Catalyst operating system software
•
Console> (enable) show boot device mod_num
For example:
Console> (enable) show boot device 4
Device BOOT variable = cf:4
Step 4 To change the default boot partition to the backup, enter the command for your operating system:
Cisco IOS software
•
Router(config)# boot device module mod_num cf:{4 | 5}
Catalyst operating system software
•
Console> (enable) set boot device cf:{4 | 5} mod_num
To boot the FWSM into the maintenance partition, enter the command for your operating system at the
Step 5
switch prompt:
For Cisco IOS software, enter the following command:
•
Router# hw-module module mod_num reset cf:1
For Catalyst operating system software, enter the following command:
•
Console> (enable) reset mod_num cf:1
To session in to the FWSM, enter the command for your operating system:
Step 6
Cisco IOS software
•
Router# session slot number processor 1
Catalyst operating system software
•
Console> (enable) session module_number
To log in to the FWSM maintenance partition as root, enter the following command:
Step 7
Login: root
Password:
By default, the password is cisco.
To set network parameters, perform the following steps:
Step 8
To assign an IP address to the maintenance partition, enter the following command:
a.
root@localhost# ip address ip_address netmask
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
24-6
Chapter 24 Managing Software, Licenses, and Configurations
OL-20748-01