Protocols And Applications; Tcp And Udp Ports - Cisco 7604 Configuration Manual

Appendix E Addresses, Protocols, and Ports

Protocols and Applications

Table E-4
Table E-4
Literal Value Description
ah
eigrp
esp
gre
icmp
icmp6 58
igmp
igrp
ip
ipinip 4
ipsec
nos
ospf
pcp
pim
pptp
snp
tcp
udp
Protocol numbers can be viewed online at the IANA website:
http://www.iana.org/assignments/protocol-numbers

TCP and UDP Ports

Table E-5
following caveats:
•
•
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
lists the protocol literal values and port numbers; either can be entered in FWSM commands.
Protocol Literal Values
51 Authentication Header for IPv6, RFC 1826.
88 Enhanced Interior Gateway Routing Protocol.
50 Encapsulated Security Payload for IPv6, RFC 1827.
47 Generic Routing Encapsulation.
1 Internet Control Message Protocol, RFC 792.
Internet Control Message Protocol for IPv6, RFC 2463.
2 Internet Group Management Protocol, RFC 1112.
9 Interior Gateway Routing Protocol.
0 Internet Protocol.
IP-in-IP encapsulation.
50 IP Security. Entering the ipsec protocol literal is
equivalent to entering the esp protocol literal.
94 Network Operating System (Novell's NetWare).
89 Open Shortest Path First routing protocol, RFC 1247.
108 Payload Compression Protocol.
103 Protocol Independent Multicast.
47 Point-to-Point Tunneling Protocol. Entering the pptp
protocol literal is equivalent to entering the gre protocol
literal.
109 Sitara Networks Protocol.
6 Transmission Control Protocol, RFC 793.
17 User Datagram Protocol, RFC 768.
lists the literal values and port numbers; either can be entered in FWSM commands. See the
FWSM uses port 1521 for SQL*Net. This is the default port used by Oracle for SQL*Net. This
value, however, does not agree with IANA port assignments.
FWSM listens for RADIUS on ports 1645 and 1646. If your RADIUS server uses the standard ports
1812 and 1813, you can configure FWSM to listen to those ports using the authentication-port and
accounting-port commands.
Protocols and Applications
E-11