Cisco 7604 Configuration Manual page 553

Chapter 24 Managing Software, Licenses, and Configurations
This address is the address for VLAN 1, which is the only VLAN used by the maintenance partition.
Using an address in the 10.3.1.0/24 subnet for the maintenance partition IP address can cause
communication problems with other hosts on that subnet; the FWSM uses 10.3.1.1 for internal
diagnostics.
To assign a default gateway to the maintenance partition, enter the following command:
b.
root@localhost# ip gateway ip_address
(Optional) To ping the FTP server to verify connectivity, enter the following command:
c.
root@localhost# ping ftp_address
Step 9 To download the application software from the FTP server, enter the following command:
root@localhost# upgrade ftp://[user[:password]@]server[/path]/filename cf:{4 | 5}
cf:4 and cf:5 are the application partitions on the FWSM. Install the new software to the backup
partition.
Follow the screen prompts during the upgrade.
Step 10 To log out of the maintenance partition, enter the following command:
root@localhost# logout
Step 11 To reboot the FWSM into the backup application partition (that you set as the default in
the command for your operating system:
• For Cisco IOS software, enter the following command:
Router# hw-module module mod_num reset
• For Catalyst operating system software, enter the following command:
Console> (enable) reset mod_num
Step 12 To session in to the FWSM, enter the command for your operating system:
Cisco IOS software
•
Router# session slot number processor 1
Catalyst operating system software
•
Console> (enable) session module_number
By default, the password to log in to the FWSM is cisco (set by the password command). If this partition
does not have a startup configuration, the default password is used.
Enter privileged EXEC mode using the following command:
Step 13
hostname> enable
The default password is blank (set by the enable password command). If this partition does not have a
startup configuration, the default password is used.
Each application partition has its own startup configuration, so you might need to copy a current
Step 14
configuration to the application partition. If you have an old configuration running on this partition, you
might want to clear it before copying to the running configuration. To clear the running configuration,
enter the clear configure all command. To copy the configuration to the running configuration, use one
of the following methods:
Paste the configuration at the command line.
•
To copy from a TFTP server, enter the following command:
•
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Installing Application or ASDM Software
Step 4), enter
24-7