Cisco 7604 Configuration Manual page 94

Configuring a Security Context
The server must be accessible from the admin context. The filename does not require a file
extension, although we recommend using ".cfg". If the configuration file is not available, you see
the following message:
WARNING: Could not fetch the URL ftp://url
INFO: Creating context with default config
You can then change to the context, configure it at the CLI, and enter the write memory command
to write the file to the FTP server.
http[s]://[user[:password]@]server[:port]/[path/]filename
•
The server must be accessible from the admin context. The filename does not require a file
extension, although we recommend using ".cfg". If the configuration file is not available, you see
the following message:
WARNING: Could not fetch the URL http://url
INFO: Creating context with default config
If you change to the context and configure the context at the CLI, you cannot save changes back to
HTTP or HTTPS servers using the write memory command. You can, however, use the copy tftp
command to copy the running configuration to a TFTP server.
tftp://[user[:password]@]server[:port]/[path/]filename[;int=interface_name]
•
The server must be accessible from the admin context. Specify the interface name if you want to
override the route to the server address. The filename does not require a file extension, although we
recommend using ".cfg". If the configuration file is not available, you see the following message:
WARNING: Could not fetch the URL tftp://url
INFO: Creating context with default config
You can then change to the context, configure it at the CLI, and enter the write memory command
to write the file to the TFTP server.
To change the URL, reenter the config-url command with a new URL.
See the
changing the URL.
For example, enter the following command:
hostname(config-ctx)# config-url ftp://user1:passw0rd1@10.1.1.1/configlets/test.cfg
(Optional) To assign the context to a resource class, enter the following command:
Step 5
hostname(config-ctx)# member class_name
If you do not specify a class, the context belongs to the default class. You can only assign a context to
one resource class.
For example, to assign the context to the gold class, enter the following command:
hostname(config-ctx)# member gold
(Optional) To map a context to a specific memory partition, enter the following command:
Step 6
hostname(config-ctx)# allocate-acl-partition partition_number
The partition_number is an integer from 0 to the number of partitions available, minus 1. The default is
12 partitions, so the range is 0 to 11. See the
page 4-13
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
4-30
"Changing the Security Context URL" section on page 4-33
to configure the number of memory partitions.
Chapter 4
for more information about
"Setting the Number of Memory Partitions" section on
Configuring Security Contexts
OL-20748-01