Using the Command-Line Interface
This appendix describes how to use the CLI on the FWSM, and includes the following sections:
•
•
•
•
•
•
•
•
•
•
•
The CLI uses similar syntax and other conventions to the Cisco IOS CLI, but the FWSM operating
Note
system is not a version of Cisco IOS software. Do not assume that a Cisco IOS CLI command works
with or has the same function on the FWSM.
Firewall Mode and Security Context Mode
The FWSM runs in a combination of the following modes:
•
•
Some commands are only available in certain modes.
Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM
OL-20748-01
Firewall Mode and Security Context Mode, page C-1
Command Modes and Prompts, page C-2
Syntax Formatting, page C-3
Abbreviating Commands, page C-3
Command-Line Editing, page C-3
Command Completion, page C-3
Command Help, page C-4
Filtering show Command Output, page C-4
Command Output Paging, page C-5
Adding Comments, page C-5
Text Configuration Files, page C-6
Transparent firewall or routed firewall mode
The firewall mode determines if the FWSM runs as a Layer 2 or Layer 3 firewall.
Multiple context or single context mode
The security context mode determines if the FWSM runs as a single device or as multiple security
contexts, which act like virtual devices.
A P P E N D I X
C
C-1