Ip Address Groups; Snmp - Cisco RV260 series Administration Manual

IP Address Groups

IP Address Groups
In order to configure and manage the application control policies and web filtering, you must set up the IP
address groups. To configure the IP address groups, follow these steps:
Step 1
Click System Configuration> IP Address Groups.
Step 2 Under IP Address Groups, click Add to add a group and enter a name. To delete a group click Delete.
Step 3
Click Add and enter the following information.
Type and Address Details
Step 4
Click Apply.

SNMP

Simple Network Management Protocol (SNMP) is an Internet-standard protocol for collecting and organizing
data on managed devices on the IP networks. It allows network administrators to manage, monitor, and receive
notifications of critical events as they occur on the network. The device supports version v1, v2c, and v3.
The device acts as an SNMP agent that replies to the SNMP commands from the SNMP Network Management
Systems. The command it supports are the standard SNMP commands get/next/set. It also generates trap
messages to notify the SNMP manager when alarm conditions occur. Examples include reboots, power cycles
and WAN link events.
Step 1
To configure the router's SNMP, enter the following information:
SNMP Enable
Allow user access from
Internet
Allow user access from VPN
Version
System Name
System Contact
System Location
Get Community
RV260x Administration Guide
40
Select the type of group from the drop-down list, and enter the address details:
• Single IP – Enter an IP address in the Address Details field.
• IP Address Subnet – Enter an IP address in the Details Address field.
• IP Address Range – Enter an IP address in the Details Address field.
Check to enable SNMP.
Check to allow user from the Internet.
Check to allow user access from VPN.
Select the version from the drop-down list.
Enter a system name.
Enter a system contact.
Enter a system location.
Enter a name for the community.
System Configuration