Installing The Treadle Unit (When Using The Treadle); When Setting Up On Top Of The Table; When Embedding Into The Table - Brother RH-9820 Instruction Manual

3. INSTALLATION

3-12. Installing the treadle unit (when using the treadle)

3-12-1. When setting up on top of the table

3-12-2. When embedding into the table

15
NOTE:
Before installing the machine head, install the three
treadle unit mounting bolts (A) to the table. (Refer to
"3-4-1. When setting up on top of the table".)
(1) Treadle unit
(2) Plain washers [3 pcs.]
(3) Spring washers [3 pcs.]
(4) Nuts [3 pcs.]
Pass the connector of the treadle unit (1) into the control box
through the hole in the rear of the control box. (Refer to "3-8.
Installing the operation panel".)
* Use a commercially-available treadle (5) and connecting
rod (6).
<Treadle operation method>
When the treadle (5) is depressed to the 1st step, the work
clamp will be lowered, and when it is depressed to the 2nd
step, the sewing machine will start.
1st step
2nd step
0359B
(1) Treadle unit
(2) Screws [3 pcs.]
Pass the connector of the treadle unit (1) into the control box
through the hole in the rear of the control box. (Refer to "3-8.
Installing the operation panel".)
* Use a commercially-available treadle (3) and connecting
rod (4).
<Treadle operation method>
When the treadle (3) is depressed to the 1st step, the work
clamp will be lowered, and when it is depressed to the 2nd
step, the sewing machine will start.
1st step
2nd step
0360B
RH-9820
4441Q
4441Q