Installing The Hand Start Switch (When Using The Hand Start Switch) - Brother RH-9820 Instruction Manual

3-13. Installing the hand start switch (when using the hand start switch)

[When setting up on top of the table]
[When embedding into the table]
(1) Hand start switch
0362B
(2) Screws [2 pcs.]
(3) Cord holders [3 pcs.]
(4) Screws [3 pcs.]
* When setting up on top of the table, use only two of the
cord holders (3) and screws (4).
Pass the cord of the hand start switch (1) through the table
hole (5), and pass the connector into the control box through
the hole in the rear of the control box. (Refer to "3-8. Installing
the operation panel".)
[When setting up on top of the table]
Insert the cord into the quick tube (6), and then pass it
through the table hole (5).
* This is to prevent damage from the cord rubbing against
the table hole (5) when the machine head is tilted back
and returned.
<Hand start switch operation method>
When the work clamp switch (left side) is depressed, the
work clamp will be lowered, and when the start switch (right
side) is depressed, the sewing machine will start.
0363B
0385B
RH-9820
3. INSTALLATION
Start switch
Work clamp switch
0364B
(Continued on next page)
16