Installing The Pneumatic Unit (Pneumatic Work Clamp Specifications) - Brother BAS-311H Basic Operation Manual

Hide thumbs Also See for BAS-311H:

Table of Contents

3. INSTALLATION

3-11. Installing the pneumatic unit (pneumatic work clamp specifications)

Connect each air tube to the position with the corresponding number.

Cylinder L

You can use the valve knobs to adjust the lifting and lowering speeds.

The valve knobs should be adjusted so that the left and right sides of the work clamp operate at the same speed.

• When the upper knob is tightened, the lifting speed becomes slower. When it is loosened, the lifting speed becomes faster.

• When the lower knob is tightened, the lowering speed becomes slower. When it is loosened, the lowering speed becomes

faster.

You can operate the work clamp while the power is turned off by pressing the manual button.

1904B

Cylinder R

Upper knob

Lower knob

Manual button

BAS-311H

Install underneath the work table.

(1) Solenoid valve assembly

(2) Washers [2 pcs.]

(3) Wood screws [2 pcs.]

(4) Rubber hose

After installing the pneumatic unit, adjust

the air pressure.

(Refer to "10-16. Adjusting the air

pressure" in the instruction manual CD.)

NOTE:

Make sure that the pneumatic unit

does not touch the control box or the

work table leg.

3097B

1905B

Table of Contents