When Embedding Into The Table - Brother RH-9820 Instruction Manual

3-1-2. When embedding into the table

When embedding the machine head into the table, some extra components will be required, so contact the place of purchase
for further details.
NOTE:
When embedding the machine head into the table, be sure to install the L-shaped table reinforcement plates. (Refer to "3-3.
Installing the table reinforcement plates (embedded installation only)".)
4 x 4 mm dia.
20 depth
(From underneath
table)
For valve unit
For cotton stand
For table leg
For bed support plate
For pneumatic unit
Shaded area should
be C10
RH-9820
For L-shaped reinforcement plates
For operation panel
4 x 2 mm dia. 10 depth
2x 2mm dia. 10 depth
(from underneath
table)
For power switch
3. INSTALLATION
For operation panel cord
For control box
Melamine veneer panel
0339B
6