Brother RH-9820 Instruction Manual page 26

3. INSTALLATION
17
<Adjusting the hand start switch position>
Adjust the position of the hand start switch (1) as follows so
that it is in an easy-to-use position.
[Forward/back and vertical position]
1. Loosen the two screws (2), and then move the hand start
switch mounting plate (7) forward, back, up or down to
adjust its position.
2. Once adjustment is complete, securely tighten the
screws (2).
0311B
0312B
RH-9820
[Forward/back and
position]
•
The hand start switch mounting plate
(7) has three screw holes in it. You
can select the installation position
from either <A> or <B> shown in the
illustration by changing the screw
holes used by the screws (8).
•
In addition, when the screws (8) are
loosened, the hand start switch (1)
can be moved forward, back and
sideways to adjust its position. Once
adjustment is complete, securely
tighten the screws (8).
sideways