Threading The Threads When The Cotton Stand Is Installed On The Right Side - Brother RH-9820 Instruction Manual

4-5. Threading the threads when the cotton stand is installed on the right side

When the cotton stand is installed on the right side, thread the threads through the parts shown inside the dotted lines below.
The parts outside the dotted lines should be threaded in the same way as when the cotton stand is installed on the left side.
Refer to "4-2" to "4-4" for details on threading each of the threads.
•
Before threading any of the threads, move the thread spool pin (1) to the position shown in the illustration, and then install
the accessory thread spool pin (2).
•
When installing the cotton stand on the right side, it is recommended that you use the accessory thread guide (3).
(4) Lower thread
(5) Gimp
(6) Upper thread
Install the thread spool pins (1) and (2) so that their
thread holes face as shown in the illustration below.
RH-9820
4. PREPARATION BEFORE SEWING
Operator
Direction of thread holes
0405B
34