Loading Sewing Data; Setting The Program Number - Brother BAS-342G Instruction Manual

6. USING THE OPERATION PANEL (BASIC OPERATIONS)

6-2. Loading sewing data

Refer to "8-1. Notes on handling CF cards (sold separately)" for details on using CF cards.
1
2
3
4
Loading complete
The PROGRAM No. display will change from " P" to the selected program number.
Turn off the power switch, remove the CF card, and then close the cover of the CF slot.

6-3. Setting the program number

29
CF media indicator illuminates
Loading
4012M
BAS-342G
With the power turned off, insert the CF card into the CF
slot.
NOTE:
• Make sure the CF card is facing the correct way
when inserting it.
• Always be sure to keep the cover closed except
when inserting and removing the CF card. If this is
not done, dust may get inside and cause problems
with operation.
Turn on the power switch.
or
Press the key to select the program number
(100 − 999).
* The "---" display is used to check the feed home
position.
Press the R/W key.
• The buzzer will sound and the selected sewing data
will be loaded from the CF card and copied into the
sewing machine's internal memory.
1. Press the or key (1) to select the program number
that is loaded into the internal memory.
• The program number will flash in the PROGRAM No.
display (2).
• "---" will appear at the time of shipment from the
factory. (For checking feed home position)
2. Depress the work clamp switch (3) to lower the work
clamp, and then depress the start switch (4).
• The work clamp will move to the sewing start position,
and then the program number will be applied.
• The program number will stop flashing and illuminate
steadily.
NOTE:
After completing the setting, be sure to refer to "6-6.
Checking the sewing pattern" to check that the needle
drop position is correct.
4453Q
4421Q
4457Q
4498Q