Completing The Installation; Completing The Hp Netserver Lh 3 Installation - HP D7171A - NetServer - LPr Installation Manual

Chapter 1

Completing the Installation

Complete the processor module installation by installing the system board,
covers, and bezel.
CAUTION
Never operate this NetServer without first installing all
covers and the front bezel. Operating the system without all
covers in place reduces critical cooling airflow over some
components, such as hard disk drives and processor modules.
Operating the system without all covers in place may result in
failure of these components.
Separate procedures follow to complete installation for the HP NetServer LH 3
and the HP NetServer LH 3r.

Completing the HP NetServer LH 3 Installation

To complete the installation:
CAUTION
Replace all covers before operating the HP NetServer, even
for a short time. Otherwise, damage to system components
can result due to improper cooling flow.
1. Install cover 3 by inserting the cover tabs into slots on the chassis. Slide
the cover toward the rear of the chassis and tighten the thumbscrew.
2. Install the bezel.
3. Confirm that all cables are attached firmly.
4. Power up the system and verify that the system fan and processor fan are
operating.
Proceed to the section "Updating the BIOS" later in this chapter.
20
Processor Module Installation