HP D7171A - NetServer - LPr Installation Manual page 26

Chapter 1
4. See Figure 1-15. Slide the server into the rack and attach the bezel hinge
to the two (previously installed) rack nuts on the left column (refer to
Figure 1-7) by means of two screws. Secure the latch plate on the right
side of the server to the two previously installed rack nuts on the right
column.
22
Figure 1-15. Attaching the Bezel Hinge
Processor Module Installation
2. Attach the
latch plate to
the front
column with
two screws
into the rack
nuts previously
placed.
1. Attach
hinge
to rack
nuts previously
placed.