Table of Contents
Advertisement
IP Filtering
Table (12):
Add PC (13):
Delete
Selected (14):
Delete All (15):
After you finish the settings, click "Apply" (16) and the following
message will be displayed on your Web browser:
Click "Continue" to go back and continue with the router setup
procedure, or click "Apply" to reboot the router so the settings will
take effect. (Wait for about 30 seconds while the router reboots.)
If you want to reset all settings on this page back to previously
saved values, click "Cancel."
the network; if you select "Allow," only IP
addresses listed in the filtering table will be able
to connect to the network, and all other network
devices will be rejected.
All existing IP addresses in the filtering table will
be listed here.
Click to add a new IP address to the IP filtering
table. Up to 20 IP addresses can be added.
(Refer to section 3-3-1-1 Add PC below.)
If you want to delete a specific IP address entry,
check the "Select" box of the IP address you
want to delete, then click "Delete Selected."
(You can select more than one IP address.)
If you want to delete all IP addresses listed here,
click "Delete All."
102
Advertisement
Table of Contents
