Yksetenv Command Format - HP StorageWorks P9000 Software Installation Manual

The following shows an example of defining a symbol when you do want to output the CLI
command-execution logs:
START YKSETENV,PARM='SYSLOG=YES'
NOTE: The setting made by executing the YKSETENV command (of Business Continuity Manager
earlier than version 5.1) with SYSLOG=YES specified has the same effect as the setting made by
executing the YKSETENV command (of Business Continuity Manager 5.1 or later) with no SYSLOG
parameter specified. So, be careful when multiple versions of Business Continuity Manager are
used in one environment, or when performing an upgrade.
Defining a system symbol in the IEASYMxx parmlib member
The following shows an example of defining a symbol when you do not want to output the CLI
command-execution logs:
SYMDEF(&YKSYSLG='NO')
The following shows an example of defining a symbol when you do want to output the CLI
command-execution logs:
SYMDEF(&YKSYSLG='YES')
If &YKSYSLG is omitted, or if an incorrect value is specified, YES is assumed.

YKSETENV command format

The following shows the formats of the YKSETENV commands. For details about command formats,
see "Command Format" (page
Format
START YKSETENV,
Function
Parameters
38 Installing Business Continuity Manager
110).
PARM='{YKCMDIF=[host-id] |
YKLCNSE=[prefix1]|
YKLCNS2=[prefix2]|
LOGPUT=[LOGR|SAM]|
SYSLOG=[YES|NO]}[,...]'
Sets the following Business Continuity Manager environment variables:
Host ID.
Prefix for the license information dataset.
BCM Log output method.
Whether or not CLI command-execution logs are output to SYSLOG.
YKCMDIF=[host-id] ~ <2-digit
hexadecimals> ((00 to 1F))
YKLCNSE=[prefix1] ~ <8 or fewer
alphanumeric characters>
For the host ID, specify a value that is
unique among hosts (operating systems).
The specified value for the host ID is given
priority over the &YKCMDIF system symbol
in the IEASYMxx parmlib member. If this
command is executed with the host ID
omitted (PARM='YKCMDIF=' is specified),
the value of the &YKCMDIF system symbol
will be used.
Specify a prefix1 for the license
information dataset so that the name of
the dataset is unique. If the prefix1 is
omitted, specify PARM='YKLCNSE='.
For details about the prefix1 for the
license information dataset, see section
"Naming Conventions for License
Information Datasets" (page 44).