Setting Up The Resource Access Control (Racf) Facility When Linking With P9000 Replication Manager - HP StorageWorks P9000 Software Installation Manual

the Business Continuity Manager agent job. The names of the configuration files to which READ
permission is to be granted are the following datasets that has the prefix specified in Business
Continuity Manager's Set Defaults panel.
Disk configuration definition file
Copy group definition file
Route list definition file
Command device definition file
To create or update the copy group definition from P9000 Replication Manager, grant WRITE
permission for the datasets listed below to the Business Continuity Manager agent job. For details
on dataset names, see
Disk configuration definition file
Copy group definition file
Temporary file of the disk configuration definition file
Temporary file of the copy group definition file
Setting Up the Resource Access Control (RACF) Facility When Linking with P9000
Replication Manager
To enable Business Continuity Manager agent communications, set an environment for the security
program (RACF).
To enable use of UNIX services, from the TSO/E you must use the RACF command to define, in
the RACF STARTED class of Business Continuity Manager agent cataloged procedure for startup.
Following is an example of using the TSO/E command with the STARTED class:
->SETROPTS GENERIC(STARTED)
->REDEFINE STARTED YKAGENT.* STDATA(USER(user-ID) GROUP(group-ID)
->SETROPTS RACLIST(STARTED) REFRESH
To start the BC Z Manager agent, you need to define one of the following profiles in the RACF
FACILITY class, and then grant the view permission for the defined profile to the administrator
user ID:
The profiles for which view permissions are granted to the Business Continuity Manager agent
vary depending on whether the Business Continuity Manager agent is started in monitor mode or
in edit mode. For details about these startup modes, see Details of Initialization Parameters.
If the Business Continuity Manager agent is started in monitor mode, grant view permissions for
the following profile:
STGADMIN.YKA.BCM.YKQUERY profile
If the Business Continuity Manager agent is started in edit mode, grant view permissions for the
following profile:
STGADMIN.YKA.BCM.COMMANDS profile
For details, see
Example of setting by using TSO/E commands:
SETROPTS CLASSACT(FACILITY)
->RDEFINE FACILITY STGADMIN.YKA.BCM.YKQUERY UACC(NONE)
->PERMIT STGADMIN.YKA.BCM.YKQUERY CLASS(FACILITY) ID(user-ID) ACCESS(READ)
For details, see
"Setting the Security" (page
"Creating Configuration File Datasets" (page
"Setting Up the Resource Access Control Facility (RACF)" (page
"Setting security for the environment configuration commands" (page 31)
31).
Setting Up the Security for Business Continuity Manager Agents
50).
TRUSTED(YES))
31).
in section
59