Cf_Kystnmode Command; Cf_Vscale Command; Cf_Vpos Command - Sanyo PLC-XU300A - 3000 Lumens Manual

PLC-XU300/350 Expand Serial Command Functional Specifications
Acceptable
Response
Unacceptable
8.7.4

CF_KYSTNMODE Command

Command "CF_KYSTNMODE_%1"[CR]
"STR" --------- Set Keystone store mode to Store
%1
"RST" --------- Set Keystone store mode to Reset
Set Keystone store mode
Details
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.7.5

CF_VSCALE Command

Command "CF_VSCALE_%1"[CR]
"032" --------- +32
"031" --------- +31
ÿ
"002" --------- +2
"001" --------- +1
"000" --------- +0
%1 "-01" ---------- -1
"-02" ---------- -2
ÿ
"-31" ---------- -31
"-32" ---------- -32
"UP" ---------- Vertical Scale setting value + 1
"DN" ---------- Vertical Scale setting value - 1
Set Vertical Scale
This command is available in normal Power ON status.
Note1) When Screen setting is not in Custom mode, projector changes image
Details
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not excute.
Acceptable
Response
Unacceptable
8.7.6

CF_VPOS Command

Command "CF_VPOS_%1"[CR]
"015" --------- +15
"014" --------- +14
ÿ
"002" --------- +2
"001" --------- +1
"000" --------- +0
%1 "-01" ---------- -1
"-02" ---------- -2
ÿ
"-14" ---------- -14
"-15" ---------- -15
"UP" ---------- Vertical Position setting value + 1
"DN" ---------- Vertical Position setting value – 1
Details Set Vertical Position
"000"[CR]
"Error Code"[CR]
"201"[CR] ----When reaching the Keystone correction limit or
reaching 1 step to correction limit and "FDN"/"FUP"
is received.
(The command is not executed)
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
28 / 66