Cf_Image Command; Cf_Imageadj Command - Sanyo PLC-XU300A - 3000 Lumens Manual

PLC-XU300/350 Expand Serial Command Functional Specifications

8.4.11 CF_IMAGE Command

Command "CF_IMAGE_%1"[CR]
"DYNAMIC" ------ Dynamic (Fixed value to enable projection with a sharp, powerful
"STAND" ---------- Standard (Image adjust value is set to factory default)
"REAL" ------------ Real (Fixed value to display graphic image with natural tone)
"CINEMA" -------- Cinema (Fixed value to focus on tone reproduction for movie)
"BLACKBOARD" – Blackboard (Fixed value to project image onto green-colored
%1
"COLORBOARD " – Colorboard(Fixed value to project image onto colored board)
"CUSTOM1" ----- Image1 (the value set and stored by a user)
"CUSTOM2" ----- Image2 (the value set and stored by a user)
"CUSTOM3" ----- Image3 (the value set and stored by a user)
"CUSTOM4" ----- Image4 (the value set and stored by a user)
Select Image Mode
Parameter "CUSTOM1" to "CUSTOM4" is the same as "Image1" to "Image4"
displayed when selecting Image on OSD menu.
Details
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.4.12 CF_IMAGEADJ Command

Command "CF_IMAGEADJ_%1"[CR]
"RST" ------- Reset Image adjustment
"STR1" ----- Store current Image adjustment to Image 1
%1 "STR2" ----- Store current Image adjustment to Image 2
"STR3" ----- Store current Image adjustment to Image 3
"STR4" ----- Store current Image adjustment to Image 4
Reset / store Image adjustment.
Parameter "STR1" to "STR4" is the same as "Image1" to "Image4" displayed when
adjusting Image on OSD menu and selecting "Store"
Details
The value stored to "Image1-4" is saved and its setting is effective even after ALL
is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
picture tone)
blackboard)
blackboard)
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
19 / 66