Cf_Hscale Command; Cf_Hpos Command - Sanyo PLC-XU300A - 3000 Lumens Manual

PLC-XU300/350 Expand Serial Command Functional Specifications
This command is available in normal Power ON status.
Note1) When Screen setting is not in Custom mode, projector changes image
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not excute..
Acceptable
Response
Unacceptable
8.7.7

CF_HSCALE Command

Command "CF_HSCALE_%1"[CR]
"032" --------- +32
"031" --------- +31
ÿ
"002" --------- +2
"001" --------- +1
"000" --------- +0
%1 "-01" ---------- -1
"-02" ---------- -2
ÿ
"-31" ---------- -31
"-32" ---------- -32
"UP" ---------- Horizontal Scale setting value + 1
"DN" ---------- Horizontal Scale setting value - 1
Set Horizontal Scale
This command is available in normal Power ON status.
Note1) When Screen setting is not in Custom mode, projector changes image
Details
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not excute.
Acceptable
Response
Unacceptable
8.7.8

CF_HPOS Command

Command "CF_HPOS_%1"[CR]
"015" --------- +15
"014" --------- +14
ÿ
"002" --------- +2
"001" --------- +1
"000" --------- +0
%1 "-01" ---------- -1
"-02" ---------- -2
ÿ
"-14" ---------- -14
"-15" ---------- -15
"UP" ---------- Horizontal Position setting value + 1
"DN" ---------- Horizontal Position setting value - 1
Set Horizontal Position
This command is available in normal Power ON status.
Note1) When Screen setting is not in Custom mode, projector changes image
Details
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not excute.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
29 / 66