Cf_Rear Command; Cf_Keystone Command; Cf_Kystnmode Command - Sanyo PLC-WTC500AL - 5000 Lumens Manual

PLC-WTC500L Expand Serial Command Functional Specifications

8.7.4 CF_REAR Command

Command "CF_REAR_%1" [CR]
"ON" --------------------------- Set Rear to ON.
%1
"OFF" ------------------------- Set Rear to OFF.
Set/Cancel Rear mode (Available only in the normal Power ON status)
When Rear is ON, projected image is left/right reversed.
Details
The status set by this command is stored in EEPROM and setting remains
effective even after the power is turned to ALL OFF status.
Acceptable
Response
Unacceptable

8.7.5 CF_KEYSTONE Command

Command "CF_KEYSTONE_%1"[CR]
"UP" ------------- Correct Keystone distortion to reduce upper part of image
"FUP" ----------- Correct Keystone distortion to reduce upper part largely
"DN" ------------- Correct Keystone distortion to reduce lower part of image
"FDN" ----------- Correct Keystone distortion to reduce lower part largely
%1 "LEFT" ---------- Correct Keystone distortion to reduce left part of image
"FLFT" ---------- Correct Keystone distortion to reduce left part largely
"RIGHT" -------- Correct Keystone distortion to reduce right part of image
"FRGT" --------- Correct Keystone distortion to reduce right part largely
"RST" ------------ Reset Keystone to default status
Change Keystone distortion correction
(Available only in the normal Power ON status)
When reached the limit of the correction level, projector accepts the command but
does not execute it. Receiving this command immediately invokes the operation.
When trying to set the value beyond available range, error code "201" is returned
Details
and the operation is not executed.
Example 1: When the correction level of the upper part has reached its upper limit
Example 2: When the upper part correction allows only another step, and then the
Acceptable
Response
Unacceptable

8.7.6 CF_KYSTNMODE Command

Command "CF_KYSTNMODE_%1"[CR]
"STR" --------- Set Keystone store mode to Store
%1
"RST" --------- Set Keystone store mode to Reset
Details Set Keystone store mode (Available only in the normal Power ON status)
Acceptable
Response
Unacceptable
"000" [CR]
"Error Code" [CR]
and then the command "UP" is received.
command "FUP" is received.
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
29/75