Cf_Coltemp Command; Cf_Progv Command; Cf_Nzred Command - Sanyo PLC-XU300A - 3000 Lumens Manual

PLC-XU300/350 Expand Serial Command Functional Specifications
8.4.8

CF_COLTEMP Command

Command "CF_COLTEMP_%1"[CR]
"000" ------ Xlow
"001" ------ Low
%1
"002" ------ Mid
"003" ------ High
Set Color Temperature. (Available only in the normal Power ON status)
The value set by this command will not be saved to the projector. Therefore, when
Details turning into Stanby-mode or ALL is OFF, the value returns to original setting. (The
value is held in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
8.4.9

CF_PROGV Command

Command "CF_PROGV_%1"[CR]
"FILM" -------- Select Progressive Mode FILM
"L1" ----------- Select Progressive Mode L1
"L2" ----------- Select Progressive Mode L2
"OFF" --------- Cancel Progressive scan
%1
"UP" -----------Switch Progressive mode in positive order
"DN" -----------Switch Progressive mode in negative order
Set / cancel Progressive scan
The value set by this command will not be saved to projector. Therefore, when
Details turning into Stanby-mode or ALL is OFF, the value returns to original setting. (The
value is held in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.4.10 CF_NZRED Command

Command "CF_NZRED_%1"[CR]
"OFF" ------- Cancel Noise Reduction
"L1" --------- Noise Reduction for moving image
"L2" --------- Noise Reduction for still image
%1 "UP" -----------Switch Progressive mode in positive order
"DN" -----------Switch Progressive mode in negative order
Noise Reduction based on frame correlation
Select L1 or L2 depending on motion detection
L2 is more effective in reducing noise than L1, however, L2 can have a blur in
moving image
Details
The value set by this command will not be saved to projector. Therefore, when
turning into Stanby-mode or ALL is OFF, the value returns to original setting. (The
value is held in Suspend mode.)
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
OFF → L1 → L2 → FILM → OFF
OFF → FILM → L2 → L1 → OFF
"000"[CR]
"Error Code"[CR]
OFF → L1 → L2 → FILM → OFF
OFF → FILM → L2 → L1 → OFF
"000"[CR]
"Error Code"[CR]
18 / 66