Cf_Disp Command; Cf_Logo Command - Sanyo PLC-XU300A - 3000 Lumens Manual

PLC-XU300/350 Expand Serial Command Functional Specifications

8.10.8 CF_DISP Command

Command "CF_DISP_%1"[CR]
"ON" ----------------------------- Select Display
"OFF" --------------------------- Cancel Display
"CNTDWNOFF" -------------- Count down OFF
"UP" --------------- Switch Display mode forward
%1
"DN" --------------- Switch Display mode backward
Set / Cancel Display
The value set by this command is stored in EEPROM and its setting is effective
Details
even after ALL is OFF.
This command is available in normal Power ON status.
Acceptable
Response
Unacceptable

8.10.9 CF_LOGO Command

Command "CF_LOGO_%1_%2"[CR]
%1 "0000"-"9999" ----------------- Set LOGO PIN CODE directly
"OFF" ---------------------------- Disable Logo function
"DFLT" --------------------------- Display Default Logo
"USER" -------------------------- Display Captured Logo
"UP" --------------- Switch Logo setting in positive order
%2
"DN" --------------- Switch Logo setting in negative order
Set / Cancel Logo
The value set by this command is stored in EEPROM and its setting is effective
even after ALL is OFF
This command is available in normal Power ON status.
%1--- Set LOGO PIN CODE
- When LOGO LOCK is in operation
PIN CODE is correct ------------------ Command is valid (Acceptable)
PIN CODE is incorrect ---------------- Command is invalid (Error Code "102")
Details PIN CODE is out of %1 range ------ Command is invalid (Error Code "? ")
-When LOGO LOCK is not in operation
PIN CODE is within %1 range ------ Command is valid
PIN CODE is out of %1 range ------ Command is invalid (Error Code "? ")
Note) Receiving correct LOGO PIN CODE while LOGO LOCK is in operation
enables to change LOGO setting, but it does not release LOGO LOCK. (LOGO
LOCK continues.)
Projector returns Error Code "101" by receiving USER in %2 when capture has
not operated.
Acceptable
Response
Unacceptable
ÿ On → Count down OFF → Off → On → 0û 0 û ÿ
ÿ On → Off → Count down OFF → On → 0û 0 û ÿ
"000"[CR]
"Error Code"[CR]
(OFF → DFLT → User → OFF → 0û 0 û )
(OFF → User → DFLT → OFF → 0û 0 û )
"000"[CR]
"Error Code"[CR]
34 / 66