Firmware configuration
Review Connect EZ default settings
You can review the default settings for your Connect EZ device by using the local WebUI or Digi
Remote Manager:
Local WebUI
1. Log into the Connect EZ WebUI as a user with Admin access.
2. On the menu, click System > Device Configuration.
Digi Remote Manager
1. If you have not already done so, connect to your Digi Remote Manager account.
2. Click Device Management to display a list of your devices.
3. Locate and select your device as described in
your
device.
4. Click Configure.
The following tables list important factory default settings for the Connect EZ.
Default interface configuration
Interface type
Wide Area Networks (WAN)
Loopback
Other default configuration settings
Feature
Central
management
Digi Connect EZ Mini User Guide
Preconfigured
interfaces
Ethernet
n
Loopback
n
Configuration
Digi Remote Manager enabled as the central management service.
n
Review Connect EZ default settings
Use Digi Remote Manager to view and manage
Devices
Default configuration
ETH
n
Loopback
n
n
n
Firewall zone:
n
Edge
WAN priority:
n
Metric=5
IP Address:
n
DHCP address
TM
Digi SureLink
n
disabled for IPv4
Firewall zone:
Loopback
IP address:
127.0.0.1/8
39