Switching Between Two Connected Cell-Phones; Clearing The Disconnection Message; Downloading The Phone Book; Using The Remote Controller (Rc-405) - Kenwood KDC-BT652U Instruction Manual

Switching between Two Connected
Cell-phones
Press to enter Bluetooth mode.
1
Press and hold
2
You cannot switch between the connected
■ ■
cell-phones during downloading of the
Phone Book.
Only the main cell-phone from which you
■ ■
can make a call.
Both the main and sub cell-phones can
■ ■
receive an incoming call.
If the other cell-phone receives an incoming
■ ■
call while you are talking on the active
cell-phone, you must finish the current call
to answer the incoming call to the other
cell-phone.
If the main cell-phone is disconnected when
■ ■
it is taken out of the vehicle, the sub cell-
phone becomes the main cell-phone if it is
held connected. When the disconnected
cell-phone is brought back into the vehicle,
it is reconnected as the sub cell-phone.

Clearing the disconnection message

Press to "HF DISCONCT" disappears.

Downloading the Phone Book

To download automatically
If the cell-phone supports a phone book
synchronization function, the phone
book is downloaded automatically after
Bluetooth connection.
Setting on the cell-phone may be required.
■ ■
Up to 1000 phone numbers can be
■ ■
registered for each registered cell-phone.
Up to 32 digits can be registered for each
■ ■
phone number along with up to 20*
characters representing a name.
(* 20: Number of alphabetical characters.
Fewer characters can be input depending
on the type of characters.)
If no phone book data is found in the unit
■ ■
even after the compete display, your cell-
phone may not support a phone book data
automatic downloading function. In this
case, try downloading manually.
20
English
.
To download from the cell-phone manually
Use this procedure when your cell-phone
does not support the Phone Book Access
Property (PBAP).
Press to enter Bluetooth mode.
1
Turn the volume knob to select
2
[SETTINGS], then press to enter.
Turn the volume knob to select
3
[TRANSFER PB], then press to enter.
"DL PB ***" is displayed.
By operating the cell-phone, send the
4
phone book data to this unit
By operating the cell-phone, download the
phone book data to this unit.
When downloading is completed, press
5
the volume knob.
The manually downloaded phone book
■ ■
data can contain up to 400 phone numbers.
When you switch between the connected
■ ■
cell-phones, the manually downloaded
phone book data is deleted.
To cancel downloading of the phone book
■ ■
data, operate the cell-phone.
Using the remote controller (RC-
405)
Making a call:
: Enter Bluetooth mode.
5 / ∞
: Selects a dialing method.
ENT 38 : Enter dialing mode.
DIRECT : Make a call.
1 — 6 : Selects preset dial.
0 — 9 : Input a digit in number dial mode.
#FM+ : Input "#" in number dial mode.
*AM– : Input "*" in number dial mode.
+¢ : Input "+" in number dial mode.
4
: Clear the entered phone number.
Receiving a call:
: Answer the call.
During a call:
SRC : End the call.
ENT 38 : Switch between the private talk
mode and the hands-free talk
mode.