Function Settings - Kenwood KDC-BT652U Instruction Manual

Function settings

Press SRC to select a source other than "STANDBY".
1
Press the volume knob to enter [FUNCTION] mode.
2
Turn the volume knob to select [AUDIO CONTROL] or [SETTINGS], then press to enter.
3
Turn the volume knob to make a selection, then press to confirm.
4
See table below for selection.
■ ■
Repeat step 4 until the desired item is selected/activated.
■ ■
Press to return to the previous item.
■ ■
Hold to finish the procedure.
5
[AUDIO CONTROL] : While listening to any source except in STANDBY state or Bluetooth mode.
Item
SUB-W LEVEL –15 — 0 * — +15: Adjusts the subwoofer output level.
BASS LEVEL –8 — 0 * — +8: Source tone memory: Adjusts the level to memorize in each source. (Before making an
adjustment, select the source you want to adjust.)
MID LEVEL
TRE LEVEL
EQ PRO
KDC-X696 only
BASS ADJUST BASS CTR FRQ
BASS LEVEL
BASS Q FACTOR 1.00 */ 1.25/ 1.50/ 2.00: Adjusts the quality factor.
BASS EXTEND
MID ADJUST MID CTR FRQ
MID LEVEL
MID Q FACTOR
TRE ADJUST TRE CTR FRQ
TRE LEVEL
PRESET EQ NATURAL */ USER/ ROCK/ POPS/ EASY/ TOP40/ JAZZ/ POWERFUL: Selects a preset sound mode suitable
to the music genre. (Selects [USER] to use the customized bass, middle, and treble settings.)
BASS BOOST B.BOOST LV1/ B.BOOST LV2/ B.BOOST LV3: Selects your preferred bass boost level. ; OFF *: Cancels.
LOUDNESS LOUDNESS LV1 */ LOUDNESS LV2: Selects your preferred low and high frequencies boost to produce a well-
balanced sound at a low volume level. ; OFF: Cancels.
BALANCE L15 — 0 * — R15: Adjusts the left and right speaker output balance.
FADER R15 — 0 * — F15: Adjusts the rear and front speaker output balance.
SUBWOOFER SET ON *: Turns on the subwoofer output. ; OFF: Cancels.
DETAILED SET
HPF THROUGH *: All signals are sent to the front speaker. ;
100/ 120/ 150 (HZ): Frequencies lower than the specified value are cut off.
LPF THROUGH *: All signals are sent to the subwoofer. ;
SUBWOOFER 85/ 120/ 160 (HZ): Frequencies higher than the specified value are cut off.
SUB-W PHASE REVERSE (180°)/ NORMAL (0°) *: Selects the phase angle of the subwoofer output to be in line with the
speaker output for optimum performance. (Selectable only if a setting other than [THROUGH] is selected for
[LPF SUBWOOFER].)
24
English
Selectable setting (Preset: *)
60/ 80/ 100 */ 200: Selects the center frequency.
–8 — 0 * — +8: Adjusts the level.
ON: Turns on the extended bass. ; OFF *: Cancels.
0.5K/ 1.0K */ 1.5K/ 2.5K: Selects the center frequency.
–8 — 0 * — +8: Adjusts the level.
0.75/ 1.00 */ 1.25: Adjusts the quality factor.
10.0K/ 12.5K */ 15.0K/ 17.5K: Selects the center frequency.
–8 — 0 * — +8: Adjusts the level.