Switching Between Two Connected Cell-Phones - Kenwood DPX405BT Manual

DPX405BT/DPX305U

13-9. Switching between Two Connected Cell-phones

13-9. Switching between Two Connected Cell-phones
When two Bluetooth devices are connected, you can assign the Bluetooth device to be
used in priority to the other Bluetooth device.
When selecting the priority device using the button
1. Press the [Ú] button.
"BT MODE" appears and enter the Bluetooth mode.
2. Press and hold [Ú] button.
The device given priority is changed.
When selecting the priority device from the Function setting mode
1. Press the [Ú] button.
"BT MODE" appears and enter the Bluetooth mode.
2. Use the [Control knob] to select "DVC PRIORITY".
For how to use the [Control knob], refer to
3. Turn the [Control knob] to select "MAIN" or "SUB".
4. Press the [Control knob].
When Sub is selected, the device given priority is changed.
Exit the Bluetooth mode.
Press the [Ú] button.
Notes
You cannot switch between the connected cell-phones during downloading of the
Phone Book.
Only the main cell-phone from which you can make a call.
Both the main and sub cell-phones can receive an incoming call.
If the other cell-phone receives an incoming call while you are talking on the
active cell-phone, you must finish the current call to answer the incoming call to
the other cell-phone.
If the main cell-phone is disconnected when it is taken out of the vehicle, the sub
cell-phone becomes the main cell-phone if it is held connected. When the
disconnected cell-phone is brought back into the vehicle, it is reconnected as the
sub cell-phone.
13. Hands-free phoning (DPX405BT)
<3-3. How to select the item>.