Preparation; How To Attach/Detach The Faceplate; How To Reset Your Unit; How To Prepare The Remote Controller - Kenwood KDC-BT652U Instruction Manual

Preparation

How to attach/detach the faceplate

1
2
Do not expose the faceplate to direct
■ ■
sunlight, excessive heat, or humidity. Also
avoid places with too much dust or the
possibility of water splashing.
Keep the faceplate in its casing while
■ ■
detached.
The faceplate is a precision component of
■ ■
the unit and can be damaged by shocks or
jolts.
To prevent deterioration, do not touch the
■ ■
terminals of the unit and faceplate with your
fingers.

How to reset your unit

If this unit fails to operate
properly, press the reset
1
button.
The unit returns to the
2
factory settings when the
reset button is pressed.
3
Reset button
4
English
1
2
How to prepare the remote
controller (RC-405)
When you use the remote controller for the
first time, pull out the insulation sheet.
Insulation sheet
If the effectiveness of the remote
controller decreases, replace the battery.
2
1
¤ Caution:
Do not set the remote control in hot places
■ ■
such as on the dashboard.
Lithium battery.
■ ■
Danger of explosion if the battery is
incorrectly replaced. Replace only with the
same or equivalent type.
The battery pack or batteries shall not be
■ ■
exposed to excessive heat such sunshine,
fire or the like.
Keep battery out of reach of children and in
■ ■
original package until ready to use. Dispose
of used batteries promptly. If swallowed,
contact a physician immediately.
CALIFORNIA, USA ONLY
This product contains a CR Coin Cell Lithium
Battery which contains Perchlorate Material –
special handling may apply.
See www.dtsc.ca.gov/hazardouswaste/
perchlorate
4
3