Processors - HP D5970A - NetServer - LCII Service & Reference Manual

c. Embedded SCSI B controller
d. PCI bus slots in the following order: P5, P6
NOTE

Processors

NOTE:
Two processor boards, each with a maximum of two CPU chips, can be installed in the system. Check
jumpers and heat sinks using the diagrams below. Speed jumpers on the board have tamper-evident seals.
The PCI controller boot priority can be changed so that the embedded SCSI
controllers precede the PCI bus slots. To do so, run the EISA Configuration Utility
and enable the option called "Boot from Embedded SCSI."
See the Technical Reference Label for the latest switch settings.
Processor Type
166 MHz 200MHz
012 PPP 012 PPP
Factory Sealed Jumpers
200MHz / 512K Processor Board
Voltage ID Processor Type
Bypass
166MHz
12 PP 012 PPP
166MHz / 512K Processor Board
ITP Scan
Heat Sinks
Skip / Include
Heat Sinks
ITP SCAN
Skip / Include
CPU 2
CPU 1
CPU 1
CPU 2
77