Adjusting The Finisher's Height - Lexmark W810n - Optra B/W Laser Printer Reference

Adjusting the finisher's height

Paper feeding problems in the finisher may occur if the height of the fin-
isher is not equal to that of the printer. Pull the finisher away from the
printer and look at the position of the transport unit to determine if the fin-
isher is at the correct height.
If the transport unit appears level, as shown in the following figure, the fin-
isher and printer are correctly aligned. See page 19 for other possible
sources of paper feeding problems.
If the transport unit is tilted either up or down, follow the steps in this sec-
tion to adjust the finisher's height.
173