Lexmark W810n - Optra B/W Laser Printer Reference page 25

Printer messages (continued)
Message
Staples Empty
Staples Low
Std Bin Full
x
Tray Empty
x
Tray Low
x
Tray Missing
x
USB
Waiting
Action
The finisher is out of staples, or the stapler is not
installed. If necessary, install a new staple cartridge
and then reinsert the stapler to clear the message.
For more information on replacing staples, see
page 148.
The finisher has less than 40 staples left in the
stapler. Install a new staple cartridge to clear the
message.
For more information on replacing staples, see
page 148.
The standard output bin is full. Remove the stack of
paper in the bin to clear the message.
The specified tray is out of paper. Load paper in the
tray to clear the message.
For more information, see "Loading paper" on
page 79.
The specified tray is low on paper. Add more paper
to clear the message.
For more information, see "Loading paper" on
page 79.
Insert the specified tray completely into the printer.
Note: If you cannot clear this message and the
specified tray is a 500-sheet paper tray (tray 2 or tray
3, or an optional tray 4), make sure the left paper
guide is properly inserted and snaps into the slot at
the front of the tray. For detailed instructions, see
step 5 on page 93.
The printer is processing data through the specified
USB port.
The printer has received a page of data to print, but
is waiting for an End of Job command, Form Feed
command, or for additional data.
When is displayed, you can:
Waiting
• Press to print the contents of the buffer.
Go
• Cancel the current job. Press
The Job Menu is displayed. Press
<Menu until Cancel Job
line of the operator panel display. Press
11
Menu> or <Menu
Menu> or
appears on the second
Select
.
.